Comments on: Jaguar X-Type Wire Mesh Grill Installation

By: walter

walter — Sat, 20 Nov 2010 19:32:03 +0000

to remove the splitter.take off the splash shield under neath .just a few screws…snap off the splitter cover.just pulls straight forward.then trim the 2 outer fins on the the inner splitter plastic mount..just the 2 outer fins..it will then slide out from underneath .the splitter is then still usable if you later desire to reuse it.

By: Darel

Darel — Sat, 29 May 2010 16:39:43 +0000

The mesh on my X-Type is approximately 8mm. I would opt for the 7mm mesh if you like this look. Good luck!

By: Nav

Nav — Sat, 29 May 2010 14:47:56 +0000

Hi, I have seen some inserta dvertised on ebay with different hole sizes but I really like yours. Could you please tell me roughly what is th hole size on your mesh? i.e. is it about 7mm square or 10mm or bigger?
Thanks and Regards
Nav

By: Darel

Darel — Mon, 06 Jul 2009 06:01:22 +0000

Donny, I’ve never done a lower grill but the folks at http://www.jaguarforums.com and http://www.jaguarforum.co.uk will almost certainly be able to help. Try searching these two forums and there’s a good chance someone has published instructions.

By: Dave Williams

Dave Williams — Wed, 24 Jun 2009 16:45:05 +0000

I thought about fitting the very latest X-Type grill (after-market) at around £200, because Jaguar say the authentic ones they supply won’t fit a 2004 model like mine. I decided to go down the mesh insert route instead as I thought it might look a little bit “who’s he kidding”, plus the mesh-kit looks cool and understated whilst giving the car a more modern and sporty look, and it’s only £60! On Hugh’s point about the Adamesh ones looking duller, I mentioned this to the chap at Adamesh and he said that shiny chrome meshes tend to corrode and rust quite quickly compared to the polished stainless steel ones they supply.

By: donny

donny — Wed, 27 May 2009 22:00:31 +0000

darel,

great explanation. put the mesh grill in on friday. used dremel to cuts slats off and evertything went great. thanks for the post. one question though, would you happen to have directions for installing to the lower grill.

thanks
donny

donmysh@yahoo.com

By: Paul

Paul — Tue, 26 May 2009 21:33:55 +0000

Fitted the adamesh grille to my 3.0 Sport last weekend using the excelent instructions and it looks great – considering the lower grille next !!!

Regards

Paul

By: Hugh

Hugh — Sat, 16 May 2009 08:20:48 +0000

Many thanks for posting these valuable instructions …The “adamesh” grill looks duller in their site photo compared withn your welsh enterprises sourced grill material.

Will be keen to see a pic from Frank prior to my own planned x type slat to mesh upgrade !

Kind regards …Hughn

By: Frank

Frank — Mon, 13 Apr 2009 23:10:34 +0000

Looks great. – I’ve just ordered a stainless mesh insert kit from “www.adamesh.co.uk” for £60 – free delivery to UK addresses.

Not sure about the lower mesh though – at £99 I might leave it for a while.

Thanks for sharing
Regards
Frank

By: jammal

jammal — Wed, 04 Feb 2009 23:49:49 +0000

thank so much my mesh came without instruction an you help me a lot. now i have to find out how to do the lower mesh